Assembly instructions

To prevent damage to the product, observe the following instructions:

• Make sure that no components are bent and/or isolation distances are changed.
• The product must not be put into operation in case of mechanical defects. Non-compliance with the applicable standards.
• Do not allow moisture, mist or toxic gas to penetrate the product.
• Avoid dust permeating the device. Allow for sufficient heat dissipation if installed in a dust-proof housing.
• Observe minimum installation distances to surrounding elements.
• Do not cover the ventilation openings.
• Install the product in accordance with the required degree of protection (e.g. control cabinet).
• Make sure that no small parts fall into the product during assembly and wiring (drilling chips, screws etc.). This also applies to mechanical components, which can lose small parts during operation.
• Secure the connection cable against mechanical influences (tension, vibrations).