Installation

DANGER

Electrical voltage in the vicinity of the device!

Danger to life due to electric shock !

1. This device is intended for installation in control cabinets or machines that can be operated under dangerous voltages. For any work on the device

1. Switch off the supply voltage of the control cabinet or machine.
2. Secure it against switching on.
3. Wait until all drives has been stopped in order that no regenerative energy can be generated.
4. Never bridge upstream protective devices. Also not for test purposes.

NOTICE

Use of suitable voltage sources!

Electric shock!

1. Only use voltage sources with protective separation (SELV/PELV) in accordance with VDE 0100 as per the stated specification.
2. Pay attention to a sufficient overvoltage category of the voltage supply.
3. With existing or newly-wired circuits the person installing the device or machine must ensure that the PELV requirements are met.

For a trouble-free and safe operation, please pay attention to the following instructions:

• The electrical installation shall be carried out in accordance with the relevant requirements.
• Cable cross-sections and fuses must be dimensioned by the user according to the specified minimum/maximum values for the application.
• When using components without isolated inputs/outputs, it is necessary that equipotential bonding exists between the components to be connected (e.g. by the equipotential line). Disregard can cause destruction of the components by equalizing currents.