Assembly instructions
Before installing the C6 E32 Rail on site, ensure that the operating environment complies with the specifications set out in this user manual and that the power supply connection and the front panel are sufficiently accessible. The product is designed for vertical installation in an industrial control cabinet.
The C6 E32 Rail is passively cooled and fanless, utilising a heat sink. The critical internal components either have their own passive cooling solutions or are directly connected to the outer casing to optimise heat transfer. The heat sink on the surface can become very hot, so precautions must be taken before handling or touching it.
Do not obstruct the airflow around the heat sink, as this may cause it to overheat. Please maintain a minimum distance around the product.
To prevent damage to the product, please follow these instructions:
- Do not put the product into operation if it has any mechanical faults. Non-compliance with the applicable standards.
- Do not install the device near heat sources or in damp places.
- Please observe the minimum installation clearances from surrounding components.
- Install the product in accordance with the required protection class (e.g. control cabinet).
- Make sure that no small parts fall into the device during assembly and wiring (drilling chips, screws etc.). This also applies to mechanical components, which can lose small parts during operation.
- Protect the connection cables from mechanical stress (tension, vibrations) in order to minimise the strain on the product’s connections.
- Only install the product in a well-ventilated area where the airflow over the heat sink is not obstructed and the product’s heat dissipation is not impeded.