General Safety Instructions

The products are developed and built according to the state of the art and recognized safety rules. Nevertheless, their use may create dangers to life and limb of the user or third parties or damage to the machine and other material property.

The following safety instructions have been created by the manufacturer for the area of electric drive technology. They can be supplemented by local, country- or application-specific safety instructions. This list is not exhaustive. Non-observance of the safety instructions by the customer, user or other third party leads to the loss of all resulting claims against the manufacturer.

The product has been manufactured and tested in accordance with the essential safety requirements for low-voltage applications (LVD) and left the manufacturer’s premises in a safe and fault-free condition. In order to maintain this condition and ensure safe operation, the operator must not only observe the correct operating conditions for the product, but also follow the general safety instructions set out below.

NOTICE

notice

Stay safe! Stay informed!

  1. Prior any work on the device
  1. Read the instruction manual.
  2. Follow all safety and warning instructions.
  3. If you are unsure of any part of these instructions, please contact KEB prior to operating the device.

DANGER

danger

Electrical voltage in the vicinity of the device!

Danger to life due to electric shock !

  1. This device is intended for installation in control cabinets or machines that can be operated under dangerous voltages. For any work on the device
  1. Switch off the supply voltage of the control cabinet or machine.
  2. Secure it against switching on.
  3. Wait until all drives has been stopped in order that no regenerative energy can be generated.
  4. Never bridge upstream protective devices. Also not for test purposes.

CAUTION

caution

The product’s heat sink can become very hot

Touching the heat sink may result in burns or injury.

  1. Do not touch the heat sink whilst the device is in operation
  2. Allow the appliance to cool down before carrying out any work on it.
  3. Wear protective gloves.

NOTICE

notice

Electronic devices and their components are sensitive to static electricity.

Failure to follow these instructions may result in damage to the device.

  1. Only trained personnel are authorised to handle and operate the product.
  2. This product must not be touched whilst outside its protective casing when it is not being used for operational purposes, unless it is otherwise protected.
  3. Where possible, please only unpack or repack this product at EOS/ESD-safe workstations.
  4. If a safe working environment cannot be guaranteed, the user must discharge any static electricity before touching the product with their hands or tools. The easiest way to do this is to touch a metal part of the system casing.

 

Only products or components that meet the requirements for power sources (PS1) as set out in UL/IEC 62368-1 may be connected to the product’s available interfaces (I/O).

Switching off the product using the power switch does not disconnect it from the mains. A complete disconnection is only possible if the mains cable is removed from the socket or from the product. Please ensure that there is unobstructed and easy access for disconnecting the connection.